Services · D.01
One engineering team for routes, trenchless crossings and calculations. We design for medium voltage, low voltage, gas, water and data, and deliver a drawing set that works in the trench as well as on paper.
D.01Engineering
Each discipline has its own page and can be ordered separately. Together they form one design.
D.01.1Route engineeringRoute engineeringWe define the route, develop it through VO, DO and UO, and record crossings and interfaces before anyone starts digging.01.1.1Route study and feasibility01.1.2VO, DO and UO01.1.3Crossings along the route01.1.4Interfaces to CROW 500View discipline
D.01.2Trenchless techniquesTrenchless techniquesWhere open excavation is not possible or not allowed, we design a trenchless crossing: from choice of technique and bore profile to permit drawing and as-drilled.01.2.1Choice of technique01.2.2Bore profile and design01.2.3Permit drawing01.2.4Supervision and as-drilledView discipline
D.01.3CalculationsCalculationsA design is only buildable if the numbers add up. We calculate trench profiles, cover, settlement and crossings, and record the assumptions.01.3.1Dimensioning01.3.2Settlement and stability01.3.3Length and height calculations01.3.4Verification against standardsView disciplineEach component can be ordered separately. Together they form one drawing that you see grow in the client portal.
We bring together everything the design needs: the KLIC delivery, the BGT base map, earlier drawings, the grid operator’s requirements and what we have seen on site. One base that everyone draws on.
ResultDesign basis with all sources on one map
Route, crossings and calculations are worked out together. A bore changes the route, a cover requirement changes the profile: you see it in one drawing, not in three separate documents.
ResultCoherent design per phase: VO, DO and UO
No drawing or calculation leaves the office without a check by a second engineer. We record that review with name and time, so it is always clear who approved what.
ResultChecked drawings with a recorded review
You receive a complete set to NLCS and the grid operator’s requirements, with the design as DXF in RD coordinates. Everything remains available in the client portal.
ResultBuildable drawing set and handover file
Don’t have everything yet? A proposed route or a question is enough to start.
Everything is stored in your project file in the client portal, also after handover.
Because route, crossings and calculations sit with one team, nobody waits for anyone else. A change in one part is processed straight away in the rest.
Yes. Route engineering, trenchless techniques and calculations can each be ordered separately. If you order several, we work them out in one coherent design.
Yes. We draw to NLCS, supplemented by the grid operator’s specific requirements. If you use your own drawing standard, we agree on it in advance.
Every drawing and calculation is checked by a second engineer. Where the subsurface is uncertain, we verify the design with a trial trench.
Next in the project
D.02Digital surveyingFrom a single survey to a full 3D picture of the subsurface: we measure, process the data and deliver it in the format you need.View service
D.03Trial trenchesWhere the KLIC delivery leaves doubt, we dig a trial trench. What we find is surveyed and processed straight into the design.View service
D.04Work preparation and permitsWe check the route for soil, nature, archaeology, unexploded ordnance and ownership, apply for the required permits and keep all parties aligned until construction.View service